Install Wall-to-Wall Carpeting -2
Before installing the carpeting, pre¬pare the floor. Move all furniture out of the room and remove doors that open into the room. Pound in any loose nails and reset squeaky floorboards with flooring nails, using a nail set to drive the heads below the floor surface. Condensation can be a problem when resilient flooring is carpeted; if the floor is covered with resilient tile or sheet flooring, remove the old flooring and then prepare the subfloor.
To complete preparations for the car¬pet installation, remove floor register covers and, if you want it to cover the carpeting, quarter-round baseboard molding. Fill in any wide cracks in the floor with wood putty, smoothed over with a putty knife, and let the patches dry completely. Vacuum the room thoroughly before you start.
The first step is nailing down the fas¬tening strips. Starting at a corner, nail strips along the edge of the floor, ¼ inch from the wall, with their teeth pointing toward the wall; use a tack hammer to drive the preset nails through the strips and into the floor. Wear work gloves to protect your hands. To make sure the strips are nailed evenly and to maintain the ¼ -inch gap, slide a ¼ -inch-thick piece of scrap wood, on edge, between the strip and the wall as you nail each fastener into place. Work around the room, sliding this guide board along the wall as you nail the fastener strips into place.
[...] be continue to: Install carpeting Related PostsInstall Wall-to-Wall Carpeting -2Before installing the carpeting, pre¬pare the floor. [...]